|
|
|
|
|
|
Basic No Blush™ stone deck sealer (1.5 gal unit)
|
Our Price: $86.00
|
|
|
To create or re-seal pebble stone decks. Coverage is about 200-250 sf per 1.5 gal unit. Best applied with split roller (see acc. section).
Curing agent selection is on the Shopping Cart page - (CURING AGENT OPTIONS: regular, fast winter, slow summer).
For ADDITIONAL INFORMATION on this and other products - CLICK HERE
|
|
|
|
|
|
|
|
|
|
|
|
|
Bio Clear 810™ tabletop epoxy (1.5 gallon unit)
|
|
Our Price: $100.00
|
|
|
A low viscosity, clear epoxy used for POUR ON epoxy table and bar tops.
For ADDITIONAL INFORMATION on this and other products - CLICK HERE
|
|
|
|
|
|
|
|
|
|
|
|
|
Bio Clear 810™ tabletop epoxy (3 gallon unit)
|
|
Our Price: $180.00
|
|
|
A low viscosity, clear epoxy used for POUR ON epoxy table and bar tops. One gal of anything will cover just over 6 sf per gallon at 1/4 inch.
For ADDITIONAL INFORMATION on this and other products - CLICK HERE
|
|
|
|
|
|
|
|
|
|
|
|
|
Bio Clear 810™ tabletop epoxy (48 oz unit)
|
Our Price: $44.00
|
|
|
A low viscosity, clear epoxy used for POUR ON epoxy table and bar tops. This selection has free shipping.
For ADDITIONAL INFORMATION on this and other products - CLICK HERE
|
|
|
|
|
|
|
|
|
|
|
|
|
Epoxy Mortar Patch™ (1.5 gal unit)
|
|
Our Price: $70.00
|
|
|
Patching potholes, chips, cracks etc. in concrete surfaces (including runways) is typically done by making lots of sand into an epoxy and making a slurry 'epoxy cement'. Honestly, the sand provides most of the desired properties, the epoxy just holds it all together. While you can add sand to almost any of our epoxies, the favorite one is this product (mostly due to price). By adding about 15 pounds of sand to this 1.5 gallon unit of epoxy, you'll get about 2.5 gallons of epoxy/sand patching material. Users in hot summer time Texas/Mexico reported about 8 minutes of work time after mixing. It would a lot longer in cooler conditions. Runway repair crews found it OK to land planes on the patch after 24 hours.
|
|
|
|
|
|
|
|
|
|
|
|
|
Industrial Floor Epoxy™ floor epoxy (1.5 gal unit)
|
|
Our Price: $92.00
|
|
|
This is the commercial quality epoxy floor paint. No Solvents, no odor, rollable but thick. Wet thickness equals dry thickness so will hide many imperfections. Note that with thick coatings air bubbles from a 'warming' concrete surface may form and get trapped in the epoxy. Usually not a issue with garages, but can be in sheds, barns etc. where the concrete is not vibrated smooth. Some people apply at night when temperatures are falling (and the air is contracting).
Coverage - just under 200 SF per 1.5 gallon unit. Apply with short nap epoxy roller (see Accessory Section).
Color selection is on the Shopping Cart page - (COLORS: light gray, beige).
For ADDITIONAL INFORMATION on this and other products - CLICK HERE
|
|
|
|
|
|
|
|
|
|
|
|
|
Industrial Floor Epoxy™ floor epoxy (1.5 quart unit)
|
|
Our Price: $44.00
|
|
|
This is the commercial quality epoxy floor paint. No Solvents, no odor, rollable but thick. Wet thickness equals dry thickness so will hide many imperfections. Note that with thick coatings air bubbles from a 'warming' concrete surface may form and get trapped in the epoxy. Usually not a issue with garages, but can be in sheds, barns etc. where the concrete is not vibrated smooth. Some people apply at night when temperatures are falling (and the air is contracting).
Coverage - just under 200 SF per 1.5 gallon unit. Apply with short nap epoxy roller (see Accessory Category). This selection has free shipping.
Color selection is on the Shopping Cart page - (COLORS: light gray, beige).
For ADDITIONAL INFORMATION on this and other products - CLICK HERE
|
|
|
|
|
|
|
|
|
|
|
|
|
NSP 120™ epoxy paint (1.5 quart unit)
|
|
Our Price: $64.00
|
|
|
Coverage - approximately 400 SF per 3 gallon unit. Apply with short nap epoxy roller (see Accessory Category). Can be applied to damp surfaces. NSF 61 (potable water approval) for tanks over 1000 gallons or pipelines over 16 inches dia. Simple 2:1 mix. Nuclear and Canadian fish farm tested/approved. This selection has free shipping.
Color selection is on the Shopping Cart page - (COLORS: white, light blue).
See links to Industrial Application Cases Studies using this product - CLICK HERE
|
|
|
|
|
|
|
|
|
|
|
|
|
NSP 120™ epoxy paint (3 gal unit)
|
|
Our Price: $320.00
|
|
|
Coverage - approximately 400 SF per 3 gallon unit. Apply with short nap epoxy roller (see Accessory Category). Can be applied to damp surfaces. NSF 61 (potable water approval) for tanks over 1000 gallons or pipelines over 16 inches dia. DBA nuclear and Canadian fish farm approvals /testing.
Color selection is on the Shopping Cart page - (COLORS: white, light blue).
See links to Industrial Application Cases Studies using this product - CLICK HERE
|
|
|
|
|
|
|
|
|
|
|
|
|
NSP 120™ epoxy paint (3 quart unit)
|
|
Our Price: $96.00
|
|
|
Coverage - approximately 400 SF per 3 gallon unit. Apply with short nap epoxy roller (see Accessory Category). Can be applied to damp surfaces. NSF 61 (potable water approval) for tanks over 1000 gallons or pipelines over 16 inches dia. DB A nuclear approvals.
Color selection is on the Shopping Cart page - (COLORS: white, light blue).
See links to Industrial Application Cases Studies using this product - CLICK HERE
|
|
|
|
|
|
|
|
|
|
|
|
|
Super Flex epoxy (1.5 gallon unit)
|
|
Our Price: $90.00
|
|
|
An amber colored, honey thick epoxy with max flex properties. You will not find a more flexible epoxy. Endless options!
|
|
|
|
|
|
|
|
|
|
|
|
|
Super Flex epoxy (48 oz unit)
|
|
Our Price: $45.00
|
|
|
An amber colored, honey thick epoxy with max flex properties. This selection includes free shipping. We asked our formulator for the most flexible epoxy he could make. This was the result!
|
|
|
|
|
|
|
